Configuring the Email Gateway for Microsoft Exchange 2013
The Email Gateway Properties dialog allows you to configure various settings for the Microsoft Exchange 2013 gateway. However, the Zetafax Configuration program will not allow you to proceed with the configuration of the Email Gateway unless you complete all of the steps described below.
Properties
| • | Click the Configure button. |
This displays a sequence of dialogs that allow you to configure the Zetafax Email Gateway for use with Microsoft Exchange 2013.
| • | Leave Polling interval set to 1 second. |
This is the interval that elapses between each occasion that the email submitter looks for new messages being forwarded by the connector.
| • | Highlight Microsoft Exchange in the Email systems column and click the Setup button. |
This displays the Microsoft Exchange Setup dialog.
Driver Information
| • | Verify that the Driver enabled box is checked. |
Exchange Server Selection
Choose an Exchange server from the Exchange Server Selection drop down box. The server list is compiled from the list of Exchange servers that have an associated Zetafax Connector. If no Zetafax Connectors have been set up in Active Directory, there will be no servers listed and you will not be able to enable the Email Gateway.
| • | Click the Test connection button to validate the connection to the chosen Exchange Hub Transport server. |
If there are any problems with the connection, you should check that the path is valid and, if using the UNC notation, that a share has been created with the right permissions. If you are still experiencing problems with the connection, please refer to the support page on the Equisys web site