Configuring dialing properties
Use standard TAPI dialing properties
Select this option to use the standard Windows dialing properties. These settings can be adjusted from the Telephony control panel.
If this option is selected then some of the Zetafax dialing properties do not need to be set. The Test numbers will still work, and should be used to check that the settings behave as intended.
Use Zetafax dialing properties
Select this option to set up dialing properties using the controls in this dialog. In some cases, particularly for versions of Windows earlier than Window '98, TAPI settings may not be sufficient to give reliable results, so Zetafax settings may be preferable.
Check the settings using the Test numbers .
Server is in this country
Select the country where your server is located from the list.
Area code
Enter you area code. If you normally include the National access code with area codes include it here (e.g. European area codes such as London 0171 are usually quoted with the national access '0').
Area rules
This button starts the Area rules dialog to configure special treatment for specific area codes.
National access code
Enter the prefix used when dialing a National area code. Zetafax will provide a default setting according to the country selected (e.g. '1' for USA, '0' for European countries). This default may be restored by clicking the Restore defaults button.
International access code
Enter the prefix used when dialing an international number. Zetafax will provide a default based on the country selection (e.g. '011' for USA, '00' for European countries.
Restore defaults
Clicking this button restores the default values for National and International access codes.
Numbers of more than .. digits contain an area code
Select this option if numbers entered by users will contain area codes without the National access code (e.g. USA). Zetafax will determine whether a number includes an area code or not by looking at the length of the number. If the number is longer than the value entered here, Zetafax will assume that the area code is included.
Numbers with area codes always begin with the national access code
Select this option if area codes always include the National access code. Numbers of any length without the National access are assumed to be local numbers.
Always dial area code (10-digit dialing)
Check this box if the area code must be dialed for local numbers.
Include the national access code
Check this box if the local area code should be dialed with the National access.
Number to test
Select a number from the list to test. The list of numbers should test all cases, but any number can also be entered by hand.
The Canonical format and dial-able number conversions for the test number are displayed so that the settings can be checked.
OK
Save the settings and exit the dialog.
Cancel
Discard all changes to the settings and exit the dialog.
Related topics